Long time no see, still learning, and getting deeper into the framework!
I am finally at the point of comprehension of the waveform view although limited. 🙂
After playing around with the customviewfour module, I am having difficulty creating a Waveform view that writes from bottom to top rather than left and right.
I believe the limitation might be the in draw function, there is only a ->setlineWidth() and no draw setlineHeight.
If anyone has any ideas, that would be awesome.
the draw function uses 2 cpoints p1 and p2 . Each point has both an x and y value.
Then the draw function just draws a line between these points.
so if you change the points you can draw however you like up down left right etc you will however have to re write the draw function. Take a look at the code in draw its not that complicated.
Ive been playing around with the draw functions lately and made a basic Oscillator Scope using drawpoint and draw line.
Hope this helps!
Most Users Ever Online: 152
Currently Browsing this Page:
Guest Posters: 1
Moderators: W Pirkle: 656