Log In
Register
Home
Topic RSS
Offline
When you change a filter you can see the differences in the out signal if you use oscilloscope in analyzer.
When you show FFTs and choose e.g. Left In / Left Out you see two different colored FFT spectra. But the out spectrum does not change when you use e.g. a filter plug-in. Is that a bug or does the analyzer not support analyzing the output signal from the plug-in?
kr
Hoegge
Offline
By default you see the outputs of each channel (Left Out/Right Out) which clearly shows the filtering that occurs.
I will check this when using single channel In/Out for the next Beta release and get back to you.
- Will
Offline
The Analyzer's In/Out function is working properly in v6.6.4.1 (current release) as well as the current Beta version.
This link shows v6.6.4.1 with a resonant lowpass filter plugin loaded and a high Q setting with Fc = 2kHz and white noise as input.
http://willpirkle.com/stuff/Analyzer.png
I also checked with normal audio and it is working properly.
As stated before, the default behavior is to show the output of the filter.
- Will
Offline
Hi Will
Sorry - it was my mistake. I noticed the Normalize to 0 dBFS was checked so the levels were kept to high.
I unchecked it but after restarting RackAFX it was checked again. Is there no way to make it stick?
- Hoegge
Most Users Ever Online: 152
Currently Online:
7 Guest(s)
Currently Browsing this Page:
1 Guest(s)
Top Posters:
Chaes: 51
Skyler: 48
Derek: 46
Frodson: 45
Peter: 43
TheSmile: 43
clau_ste: 39
jim: 34
JimmyM: 33
Gwen: 32
Member Stats:
Guest Posters: 1
Members: 696
Moderators: 1
Admins: 5
Forum Stats:
Groups: 13
Forums: 41
Topics: 757
Posts: 2894
Newest Members:
Jas, Rowan, sojourn, fabhenr, rg1, Niklas, Wutru, Tim Campbell, Danny Jonel, ValentinModerators: W Pirkle: 573
Administrators: Tom: 74, JD Young: 80, Will Pirkle: 0, W Pirkle: 573, VariableCook: 3
